-
- Settings Menu
- System Menu
- Network Settings Menu
-
Streaming Server Settings Menu
Streaming Server Settings Menu
For setting a name to distinguish the settings of this camera.
Memo
The default values are Server1/Server2/Server3/Server4.
You can enter up to 31 characters.
For setting the system to transfer videos for distribution.
Memo
Use reception devices that are compatible with the respective transfer systems.
The following items that can be set vary depending on the setting of this item.
For setting details such as the host name and the IP address of the live distribution destination.
Memo
Enter not more than 127 characters using single-byte alphanumeric characters (a to z, 0 to 9), single-byte hyphen “-” or dot “.”.
For entering the URL of the live distribution destination beginning with “rtmp://”.
There is no default value (blank).
Memo
You can enter up to 191 characters.
Enter the network port number of the live distribution destination using an integer between 1 and 65535.
The default value is 6504.
Memo
When “Type” is set to “MPEG2-TS/RTP”, only even numbers from 2 to 65530 can be specified for the port number of the destination port.
When “Type” is set to “MPEG2-TS/RTP” and “SMPTE 2022-1 FEC” is set to “On”, N+2 and N+4 port numbers are also used in addition to the specified port number (N) of the destination port.
Enter the stream key specified at the live transmission destination.
There is no default value (blank).
Memo
You can enter up to 63 characters.
Changes the password for RTSP authentication to enable client access.
There is no default value (blank).
Memo
You can enter up to 31 characters.
For configuring the setting to reduce PCR Jitter during live streaming.
Setting |
Description |
|---|---|
|
Low |
Reduces PCR Jitter. |
|
Normal |
Choose this setting if the decoder is not functioning correctly. |
Setting |
Description |
|---|---|
|
On |
Uses FEC (Forward Error Correction). |
|
Off |
Does not use FEC (Forward Error Correction). |
* The decoder must be compatible with SMPTE 2022-1.
For configuring the amount of “FEC” (Forward Error Correction) overhead when “SMPTE 2022-1 FEC” is enabled.
The amount of FEC overhead changes when the L and D values are changed.
Memo
Increasing the amount of FEC overhead increases the packet loss resilience, but more network bandwidth is used.
Even with the same amount of overhead, increasing the L value will increase the packet loss (continuous packet loss) resilience.