Global
Mobile User Guide

Interval Rec

TOP

In normal recording, when the recording stops, the image and accompanying data from the start till the end of the recording are recorded as one “clip” on the SD card.

In this mode, recording and pause are performed repeatedly at the specified time interval. Only the specified number of frames is recorded.

The recording can be written to the media as a single clip until it is stopped.

Memo

Audio will not be recorded.

Until a specified amount of recordings is accumulated, the file will not be written to the media.

After the specified number of frames is recorded and written to the media, recording will be performed until the same number is accumulated again.

If the specified amount is not reached when recording is stopped, normal recording is performed and frames are added to the ending of the clip until the amount is reached. (Padding)

Interval Rec
Set [Rec Mode] to “Interval Rec”.

Set [System] arrowR [Record Set] arrowR [Rec Mode] to “Interval Rec”.

The display changes (“STBY” arrowR “STBY BALP_I ”).

Set the number of frames to record in [Rec Frames].

To configure the setting, go to [System] arrowR [Record Set] arrowR [Rec Mode] arrowR [Rec Frames].

Set the time interval to start recording in [Interval Rec].

To configure the setting, go to [System] arrowR [Record Set] arrowR [Rec Mode] arrowR [Rec Interval].

Start recording.

Press the [REC] button to record only the number of frames specified in [Rec Frames] and pause.

After the specified time in [Rec Interval] has passed, recording starts again to record only the number of frames specified in [Rec Frames] and pause.

Interval Rec continues until the recording is stopped.
The display changes (“STBY BALP_IarrowRREC button REC BALP_IarrowR “STBY BALP_I ” (red text) arrowRREC button REC BALP_IarrowR “STBY BALP_I ” (red text)).

The card slot status indicator blinks in green.

Press and hold the [REC] button.

The card slot status indicator lights up in green.

The display becomes “STBY BALP_I ”.

Caution

Do not remove the SD card during recording ( REC button REC BALP_I , red text) or recording pause (STBY BALP_I , yellow text).

To remove the SD card during Interval Rec, press the [CANCEL] button, check that “STBY BALP_I ” (white text) is displayed and the card slot status indicator lights up in green before you remove the card.

When the [TC GENE.] switch inside the door of the LCD monitor is set to “FREE”, the time code is recorded in the “Rec Run” mode.

Audio cannot be recorded. The audio level meter is grayed out.

Global
Mobile User Guide
GY-HM890 series / GY-HM850 series
Mobile User Guide