Global
Mobile User Guide

Frame Rec

TOP

In normal recording, when the recording stops, the image and accompanying data from the start till the end of the recording are recorded as one “clip” on the SD card.

In this mode, recording starts with every press of the [REC] button, and only the specified number of frames is recorded.

The recording can be written to the media as a single clip until it is stopped.

Memo

Audio will not be recorded.

Until a specified amount of recordings is accumulated, the file cannot be written to the media.

If the specified amount is not reached when recording is stopped, normal recording is performed and frames are added to the ending of the clip until the amount is reached. (Padding)

After the specified number of frames is recorded and written to the media, recording will be performed until the same number is accumulated again.

FrameRec_02
Set [Rec Mode] to “Frame Rec”.

Set [System] arrowR [Record Set] arrowR [Rec Mode] to “Frame Rec”.

The display changes (“STBY” arrowR “STBY BALP_F ”).

Set the number of frames to record in [Rec Frames].

To configure the setting, go to [System] arrowR [Record Set] arrowR [Rec Mode] arrowR [Rec Frames].

Start recording.

Press the [REC] button to record only the number of frames specified in [Rec Frames] and pause.

The display changes (“STBY BALP_FarrowRREC button REC BALP_FarrowR “STBY BALP_F ” (yellow text)).

The card slot status indicator lights up in green.

Repeat Frame Rec.

Press the [REC] button again to record only the number of frames specified in [Rec Frames] and pause.

The display changes (“STBY BALP_FarrowRREC button REC BALP_FarrowR “STBY BALP_F ” (yellow text)).

Frame Rec continues until the recording is stopped (step Step5 ).

Press and hold the [REC] button.

The card slot status indicator lights up in green.

Caution

Do not remove the SD card during recording (“ REC button REC BALP_F ”, red text) or recording pause (“STBY BALP_F ”, yellow text).

To remove the SD card during Frame Rec, press the [CANCEL] button, check that “STBY BALP_F ” (white text) is displayed and the card slot status indicator lights up in green before you remove the card.

When the [TC GENE.] switch inside the door of the LCD monitor is set to “FREE”, the time code is recorded in the “Rec Run” mode.

Audio cannot be recorded. The audio level meter is grayed out.

Global
Mobile User Guide
GY-HM890 series / GY-HM850 series
Mobile User Guide