Global
Mobile User Guide

Trimming Recorded Clips

TOP

You can extract (trim) the necessary parts of a clip recorded in the SD card.
The trimmed clip is saved as a new file on the same SD card as the original clip. No changes are made to the original clip.

TrimingClip_890
Switch to Media mode.

Switch the mode using the [CAM/MEDIA] selection button on the side operation panel.

Move the cursor to the clip to be trimmed.

Move the cursor to the clip to be trimmed using the cross-shaped button ( U_botton D_botton L_botton   R_botton ).

TrimingClip_01_890
Press the [LOAD FILE/3] button.

The action selection screen is displayed.

Select [Trim This Clip], and press the Set button ( REC button ).

Playback of the selected clip starts.

TrimingClip_02_890

Guide

Operation guide

Position bar

TRI_Now :

Current position of the video

TRI_IN :

Position to start trimming (in point)

TRI_OUT :

Position to end trimming (out point)

Trimming information

SlotA_B or SlotB_B :

Indicates the available space in the storage media ( SlotA_B or SlotB_B )

TRI_IN :

Indicates the time code of the in point

TRI_OUT :

Indicates the time code of the out point

TRI_DU :

Indicates the duration from the in point to the out point

Memo

The trimmed clip will be saved to the same card slot as that of the original clip.

[Duration] appears in yellow if the duration is 10 minutes or longer. Trimming cannot be performed in this case.

[Duration] appears in yellow if the duration is longer than the recordable time on the storage media. Trimming cannot be performed in this case.

When trimming starts, the display switches to the Media Display 2 screen.

Specify the in point.

Operate buttons such as FAST REVERSE button / FAST FOWARD button or PREVIOUS button / NEXT button to move the video to the in point.

Specify the in point by pressing the [OIS/1] button at the point you want to start trimming.

Specify the out point.

Operate buttons such as FAST REVERSE button / FAST FOWARD button or PREVIOUS button / NEXT button to move the video to the out point.

Specify the out point by pressing the [MARKER/2] button at the point you want to end trimming.

Perform trimming.

Press the [LOAD FILE/3] button to perform trimming.

Memo

While trimming is in progress, you can press the [CANCEL] button to return to the thumbnail screen.

While trimming is in progress, you can press the [DISPLAY] button to switch the display, but the trimming information is displayed at all times.

When trimming the in and out point, the in point trimmed may be up to one second before the specified in point and the out point trimmed may be up to one second behind the specified out point.

Global
Mobile User Guide
GY-HM890 series / GY-HM850 series
Mobile User Guide