You can add the date, time or an 8-digit hexadecimal number as the user’s bit to the recorded image.
Setting the User’s Bit
TOP
Selecting a Recording Mode
Recording date/time information to the user’s bit
Set [TC/UB] 
[UB Mode] to “Date” or “Time”, and press the Set button ( 
).
[UB Mode] to “Date” or “Time”, and press the Set button ( ).The date or time information is recorded to the user’s bit.
Memo
When “Date” or “Time” is set, [Preset] appears as “-” and cannot be set.
“Time” is displayed in the 24-hour format.
Presetting the User’s Bit
Recording arbitrary information (8-digit hexadecimal) to the user’s bit
Set [Main Menu] [TC/UB] [UB Mode] to “SW Set”, and press the Set button ( ).
[TC/UB] [UB Mode] to “SW Set”, and press the Set button ( ).Move the cursor to [Preset] and press the Set button ( ).
).The [UB Preset] setting screen appears.
Memo
When the [TC GENE.] switch is set to “REGEN”, “Regen” is displayed and preset is disabled.
Use the cross-shaped button ( 
) to place the cursor at the item to set, then use the cross-shaped button ( 
) to change the values.
) to place the cursor at the item to set, then use the cross-shaped button ( ) to change the values.Numbers between 0 and 9 or alphabets between A and F can be specified for the user’s bit.
Memo
Press the [MARKER/2] button to reset each digit to “0”. The cursor moves to the left.
Check the values and press the Set button ( ).
).The user’s bit is set and the screen returns to [TC/UB].
To cancel the setting, press the [CANCEL] button.
Press the [MENU/THUMB] button.
Returns to the normal screen.
Setting User’s Bit without Opening the Menu
Memo
Settings cannot be made in the following cases.
When the [TC GENE.] switch is set to “REGEN”.
Menu screen is displayed.
The camera recorder is not in the Camera mode.
Setting the user’s bit
Set the [TC DISPLAY] switch on the LCD monitor to “UB”.
Set the [TC GENE.] switch to a setting other than “REGEN”.
Hold down the [MENU/THUMB] button and press the [OIS/1] button.
The [UB Preset] setting screen appears.
Set the user’s bit (numbers between 0 and 9, or alphabets between A and F).
Use the cross-shaped button ( ) to place the cursor at the item to set, then use the cross-shaped button ( ) to change the values.
Memo
Press the [MARKER/2] button to reset each digit to “0”. The cursor moves to the time digit (left).
Check the values and press the Set button ( ).
).The user’s bit is set and the screen returns to the normal screen.
To cancel the setting, press the [CANCEL] button.
Caution
When the camera recorder is switched to Media mode during editing, editing will be canceled and the screen will close.
When editing the user’s bit, the [OIS/1] and [MARKER/2] button operations that are set in [Main Menu] [Camera Function] [User Switch Set] are disabled. [MARKER/2] functions as the number reset button.
